Repoint or Rebuild? Reading the Mortar Joints on Your Chimney
When a chimney starts looking rough, the big question is whether it can be repaired in place or needs to be rebuilt. The answer lives in the mortar joints. Learning to read them tells you which path your chimney is on — and Gilbert’s climate leaves clear fingerprints if you know what to look for.
What the mortar is telling you
Mortar is meant to be slightly softer than the brick around it, so it wears first and protects the brick. When you look at the joints, you are reading how far that wear has gone.
Surface erosion — joints that are recessed a little, with sound brick around them — is a repointing candidate. The structure is fine; it just needs its weather seal restored. That is a tuckpointing and brick repointing job.
Deep erosion — joints you can push a finger into, mortar that crumbles to sand, gaps where you can see daylight — means water has been getting deep into the wall. If the brick is still solid, aggressive repointing may still save it. If the brick itself is failing, the calculus changes.
Spalling: the tipping point
Spalling is when brick faces flake, pop, or crumble. It happens when water gets into the brick, and the desert’s daily temperature swings and occasional freezing expand and contract that trapped water until the face breaks off. A little spalling here and there can be handled by replacing individual brick. But widespread spalling across the stack means the brick has lost its integrity — and no amount of new mortar fixes crumbling brick. That is where a repair tips toward a chimney rebuild above the roofline.
Signs that point to a rebuild
Some symptoms mean repointing won’t be enough:
- Leaning or bulging. A stack that is out of plumb has a structural problem repointing can’t correct.
- Loose or fallen brick. If brick is coming out, the bond has failed across the section.
- Widespread spalling. When most faces are flaking, the brick is spent.
- Large gaps and stepping cracks that run through both brick and mortar, not just the joints.
When several of these appear together on the section above the roof, rebuilding that section is usually the sound long-term choice.
How Gilbert’s climate drives the damage
People assume the desert is gentle on masonry because it’s dry. It isn’t. Relentless sun bakes moisture out of mortar and makes it brittle. Big day-to-night temperature swings flex the joints constantly. Then monsoon downpours drive water sideways into every open joint and crack, and it sits there until the heat or a cold snap expands it. That cycle — wet, then baked, then flexed — is exactly what erodes joints and spalls brick over time. It is also why so many chimneys here look fine for years and then decline quickly once the joints open up.
Making the call
Start with a close inspection. Press on the joints, look for spalling, check whether the stack is plumb, and note how much of the chimney is affected. Isolated surface erosion points to repointing. Widespread spalling, leaning, or failing brick points to a rebuild. Many chimneys fall in between — sound at the base, failing up top — and the right answer is repointing the good sections while rebuilding the bad ones.
If water has already been getting in, check the crown and flashing too, since those are usually the entry points; a chimney flashing and leak repair often accompanies masonry work. When you are ready to compare approaches, understanding what chimney masonry repair work involves will make the contractor’s recommendation easier to judge.